Flash-Panel Crossbuck Half Dutch Door

Flash-Panel Crossbuck Half Dutch Door

Size: 4'-0" width x 4'-0" height

Recommended Opening Measurement: 4'0-1/2" width

Add a Little "FLASH" to Your Stall Doors. Arrives Installed on Door or Install Yourself and Save! Flash Panels can be added to an Existing Armour Dutch Door, check out the Accessories page for more info.

Flash-Panel Crossbuck Half Dutch Doors are an economical stall front entry gate or oversized window shutter. This door arrives fully assembled with the highest quality materials available in the industry. There are no loose pieces, no lumber to buy and nothing to put together. All lumber is surrounded by heavy gauge, non rusting, aluminum channels and miter cut corners. These time honored "x" Half Dutch Doors arrive with unmarred lumber fascias because all wood glue and counter sunk wood placements take place in the rear of the panel. The smooth interior surface panels provide a beautiful appearance and protection for hooves. Painting or staining door lumber portion is recommended. With Armour products, no additional hardware kit is necessary, all hardware is included with purchase. Half Dutch Doors include two 6" zinc- plated "Tee-hinges," one zinc-plated Super Latch. All the necessary fasteners for lumber installations are included for the hinges and latch assembly. Half Dutch Doors come in a standard size of 48" wide by 48" high. This Flash-Panel Crossbuck Dutch stall gate will fit your opening of 48-1/2" width and may be used as a single swing shutter in any 48-1/2" wide by 48-1/2" height opening.

• Add a Little "FLASH" to Your Stall Doors
• Arrives Installed on Door or Install Yourself and Save!
• Add to an Existing Armour Dutch Door
• Completely Assembled Stall Gate with Hardware
• Old World Crossbuck "x" Design
• One 4'-0" width x 4'-0" height panel
• Heavy gauge "non-rusting" ALUMINUM metal used throughout entire gate structure (except lumber)
• Full vertical & horizontal channel coverage on both sides of door for maximum strength and protection
• Painting or staining door lumber portion is recommended.
• 6" Zinc Plated Tee-Hinges with all necessary fasteners included for installation.
• Zinc-Plated Superlatch and latching receiver plates and hardware included with all gates.
• Smooth surface panels on interiors of doors.
• All lumber secured with glue and countersunk wood screws on rear panels.