This catalog has no sub-catalogs.

Stall Divider Package for 8 foot high Stall

One L Series Aluminum Divider Grill
- Fully Welded Grill Assembly
- All welds are concealed for a clean, finished appearance!
- L4X Stall Grill assembled with 1-1/2” x 1-1/2” ANGLE on Top and Bottom Horizontals for mounting
- 1” Diameter Round Pickets and a 3” Between Bar Spacing
- Many different width/length options to choose x 4’0” Height (If you need a different size, please call us, we will accommodate your situation!)
- Pre-Drilled with Fasteners for lumber installation
- No Lumber in Lower 4’0” of Stall Wall
Two Aluminum Receiver Channels & Four Aluminum Header Channels
- Two 7-1/2" Header Channels hold the header in place above the divider grill and fasteners are included
- Two Receiver Channels: Receiver Channels are two individual channels that are NOT welded or connected to the stall grill, but are separately mounted, below where you intend to place the stall grille. Receiver Channels mount vertically to the stall end posts and, once affixed, horizontal 1-1/2" lumber can be inserted into the Receiver Channels to construct the stall's front wall. Fasteners are included.

You will need to provide
- Two 6" x 6" x 12'0" posts (One post at each stall end. When you plan for multiple stalls, please remember, stalls that are side by side will share a common post!
- Nine 2" x 6" x 12’ boards (The length of the board you will require, changes to the length of the divider you are ordering. These are used to construct the lower stall divider wall.)
- One 2" x 8" x 12' board (The length of the Header Board you will require, changes to the length of the divider you are ordering. This board is used to hold the grill in place at the top of the stall.)